Lilypad

Aan dit artikel wordt nog gewerkt. Een aantal dingen kloppen vermoedelijk niet.

The LilyPad iduino is a microcontroller board designed for wearables and e-textiles. It can be sewn to fabric and similarly mounted power supplies, sensors and actuators with conductive thread. The board is based on the ATmega168V (the low-power version of the ATmega168) (datasheet) or the ATmega328V (datasheet).
Warning: Don't power the LilyPad iduino with more than 5.5 volts, or plug the power in backwards: you'll kill it.What's more,the LilyPad iduino should only be programmed with software versions 0010 or higher. You can program it with earlier versions, but all of the time related functions will be off (twice as slow as they should be).

Microcontroller
ATmega168V
Operating Voltage
2.7-5.5 V
Input Voltage
2.7-5.5 V
Digital I/O Pins
14 (of which 6 provide PWM output)
Analog Input Pins 6
DC Current per I/O Pin 40 mA
Flash Memory 16 KB (of which 2 KB used by bootloader)
SRAM 1 KB
EEPROM 512 bytes
Clock Speed 8 MHz
Programming:The LilyPad iduino can be programmed with the iduino software. *Note*, the LilyPad iduino should only be programmed with software versions 0010 or higher. You can program it with earlier versions, but all of the time related functions will be off (twice as slow as they should be).
The ATmega168V or ATmega328V on the iduino LilyPad comes preburned with a bootloader that allows you to upload new code to it with the iduino software. You can also bypass the bootloader and program the ATmega through the ICSP (In-Circuit Serial Programming) header; see these instructionsfor details.
Power:The LilyPad iduino can be powered via the USB connection or with an external power supply.
If an external power supply is used, it should provide between 2.7 and 5.5 volts. This can come either from an AC-to-DC adapter (wall-wart) or battery. Again, don't power the LilyPad iduino with more than 5.5 volts, or plug the power in backwards: you'll kill it. Als pinnen omhoog staan aan de voorzijde dan van links naar rechts

1= gdn
2= cts
3= 3V3
4= TXD
5= RXI
6= DTR
2.FTDI Basic Breakout
The basic breakout board is for the FTDI FT232RL USB to serial IC.
The pinout of this board matches the FTDI cable to work with official Arduino and cloned 5V Arduino boards. The major difference with this board is that it brings out the DTR pin as opposed to the RTS pin of the FTDI cable. The DTR pin allows an Arduino target to auto-reset when a new Sketch is downloaded. This is a really nice feature to have and allows a sketch to be downloaded without having to hit the reset button. This board will auto reset any Arduino board that has the reset pin brought out to a 6-pin connector.It can also be used for general serial applications.
This board has TX and RX LEDs that make it a bit better to use over the FTDI cable. You can actually see serial traffic on the LEDs to verify if the board is working.


Bronnen:
Aliexpress
Ebay
Geetech